Embarking on a drywall installation project may seem complicated, but fear not! With proper guidance, even those new to DIY can complete this task.
(Photo : Pexels/ Jimmy Nilsson Masth)
Step 1: Plan
The majority of the drywall sheets consist of panels that are 4 feet wide and 8 feet long. Depending on your preference, you may hang them either horizontally or vertically. Moreover, no matter how you choose to hang the drywall, you will be required to create some cuts if the dimensions of your room are 12 feet by 18 feet. The drywall sheet should be cut as few times as possible, and the cuts should be made in incompatible places.
Step 2: Making a Wooden Frame
To position the sheets horizontally, draw a mark on two studs and measure down from the ceiling. While holding one piece of drywall, screw into each stud deeply enough to secure the wallboard pieces. A more significant portion of the wallboard can reportedly be supported.
Step 3: Tack the Drywall Sheets in Place with Drywall Nails
Placing the sheets with drywall fasteners before removing the drywall screws can offer increased durability and accuracy. To accomplish this task, proceed by meticulously positioning the measured drywall panels in their designated locations. The next step is to take some chalk and, in the areas where you will attach the sheets of plywood to the interior, mark out some marks. As mentioned, dot each corner, as well as the length and breadth, on multiple occasions. Be careful not to add too many; the purpose of tacking is to hold everything in place before the screws for the drywall are installed.
Also Read: Tunnel Construction: 5 Types of Boring Machines for Exploring the Underground
Step 4: Drive Screws Into the Drywall Sheet
Evaluate whether or not your drywall sheets are positioned most optimally once you have successfully tackled them into place. Make any necessary adjustments to achieve an impeccable appearance should you have any uncertainties. Ensure that you are using drywall screws that are compatible with the drywall; any other type of screw will not work; therefore, drill the screws into position. If you want your drywall to last as long as possible and cover as much ground as possible, it is recommended that you screw it in every 30 to 40 centimeters or 12 to 16 inches.
Step 5: Taping the Drywall
Plaster mix, also called 'mud' within the drywall community, smooths over edges where two panels meet before taping the drywall. This finishing touch will render the walls with smooth, precise edges, completing the drywall installation process. Accordingly, take your mud or use a plaster that has already been prepared and work it into a smooth consistency similar to peanut butter. Thus, a lack of masses is expected after picking up small amounts of mud with a metal spackle knife that is clean and sharp, smoothing it over any visible seams between panels.
Step 6: Sand and Finish
Once the joint compound has dried, level out any flaws or rough edges using a sanding block or sandpaper. Before applying primer, paint, or wallpaper to finish the surface of the drywall, use a moist cloth to remove any dust that may have accumulated.
Step 7: Final Touches
Finishing touches like baseboards, trim, and other elements should be put to complete the appearance of your newly completed drywall. Take a moment to appreciate your work, and be secure in the knowledge that you have successfully finished a drywall installation project of professional quality from the very beginning to the very end.
Related Article: 5 Simple Steps to Build a DIY Gravel Driveway
